119W - Not down loading some tps

[razorburn]

Using cw 700 cannot get to scan some tp--not getting all channels. Some show weak signal. Q95 S90 on chanels that do come in. Have tryed most everything I know. Using DP LNB. Scanning fine on VS.:noclue::noclue::noclue:

[Centauri]

On sat 119 it is best to make sure your TP 12239 has the best signal. If that TP is showing the best possible quality signal than all other TP's will be o.k. DN does NOT use all there TP's. some are dormant for that sat.

Its also a good idea to scan for channels on a sunny day. Erase all old channels first before rescanning, otherwise you may get double channels

[Centauri]

Your VS scans fine but your CW does not?
Check with your antenna settings and make sure all is correct on your CW.
Or you may also have a hardware problem like:
1) Bad cable
2) Switch faulty on the 119 port
3) LNB bad on the side CW is hooked to

[razorburn]

I am getting 119, but some tp are not picking up channels and or signal shows weak. Other channels that I do get (about 240) show Q-96---S-(90). Just noticed 110 is about the same-not picking up some channels. Scanned a cs6100 on same imput--scanned fine.

[Labyrinth]

after this last file many of the 700 I have ran across, had to have a factory reset done then set it all up again as the file had corrupted the works