Gugi47
09-10-2008, 09:35 PM
250SM/150M (PVR) “8882” display fix
This problem can be happened when used defective memory stick, download wrong bin-file, software jam etc. The units are still boot saved condition and fixable by yourself as follows:
1. Check www.pansatusa.com download section 250SM/150M (PVR) model and open GTROM-V25.exe loader.
2. Select right COM port of the PC to be used.
3. Connect Null Modem data cable between PC and the unit. PC should be one of RS 232 data port installed.
4. Click browser and open most updated api bin file and select application file only.
5. Click download and then turn the unit power off and on.
6. After download completed OK, still have to wait another 30-40second s until the unit fully rebooted and display ON or any channel number.
7. If failed, try above procedure again.
Still you can not fix, send to Panarex.
This problem can be happened when used defective memory stick, download wrong bin-file, software jam etc. The units are still boot saved condition and fixable by yourself as follows:
1. Check www.pansatusa.com download section 250SM/150M (PVR) model and open GTROM-V25.exe loader.
2. Select right COM port of the PC to be used.
3. Connect Null Modem data cable between PC and the unit. PC should be one of RS 232 data port installed.
4. Click browser and open most updated api bin file and select application file only.
5. Click download and then turn the unit power off and on.
6. After download completed OK, still have to wait another 30-40second s until the unit fully rebooted and display ON or any channel number.
7. If failed, try above procedure again.
Still you can not fix, send to Panarex.