cant keep sat. settings

[barlow1970]

I have my buddys CS7000 and I can set the sats. up and the 3 im working on is 91-110-119 . After getting everything set I have good signal and quality on all 3 but after I hit exit I can go back a little later and re check my settings and at least one of the sat. settings has changed and it will be dead so then I change the lnb freq. and it will pop right back in . Isnt this thing suppose to save the settings?????? It never ask to save. Any suggestions???

[Ace Rimmer]

i think i would try a tune-up first . the ole reset/fact bin/new bin . see if that helps .also are you turning the stb off at anytime?

[barlow1970]

Yes sir I did a factory reset then did a factory bin then did the latest bin.And This is happening with no powering off. Thanks for the options rimmer .

[cman082007]

when you hit exit on dish settings does it ask you if you want to save the settings?

if not try a factory reset and let it auto scan for the satellites!

[barlow1970]

It never did ask to save settings when exiting . I allways thought it asked to save settings on most stb's . Thats another thing it only finds 2 sats. so I have to manually set them up to get all 3 .

[cman082007]

when you set up the third does it tell you, you have the right sat in the upper right corner of the screen.

In other words, if your aiming for 91 but it tells you 110 in the upper right corner then that could be the problem. if thats the case then maybe a switch issue