DisEqC problem with new software?

[wlemst88]

Hi all.

Just installed the new version F software after skipping revs a-e, and I noticed that I can only lock the satellite plugged into port 1 of my DisEqC switch. I have 110 and 119 plugged into ports 2,3 of my Chieta 4x1 switch. When I disconnect the Nuvenio and connect the old Nova I have, it is able to switch between the 3 ports(sats) on the switch. Seems like the Nuvenio can't communicate with my switch any more. Any ideas or suggestions? Is my switch a POS?

TIA

[gerby]

Hi all.

Just installed the new version F software after skipping revs a-e, and I noticed that I can only lock the satellite plugged into port 1 of my DisEqC switch. I have 110 and 119 plugged into ports 2,3 of my Chieta 4x1 switch. When I disconnect the Nuvenio and connect the old Nova I have, it is able to switch between the 3 ports(sats) on the switch. Seems like the Nuvenio can't communicate with my switch any more. Any ideas or suggestions? Is my switch a POS?

TIA


Do a factory default, then let Unit do an Auto scan, hopefully it picks up sats, if not make sure your disque is st to 1.0 also what are yoour LNB's?

[wlemst88]

Do a factory default, then let Unit do an Auto scan, hopefully it picks up sats, if not make sure your disque is st to 1.0 also what are yoour LNB's?

Yeah, I've tried that. When it does the auto scan it picks up 91 on port 1 but when it scans ports 2, 3, it says "nothing detected".

I have the standard LNBs from my expressview install. The additional ones I bought for Dish are similar. Like I said, it used to work on the box prior to the software update.