Installing the card reader in a coolsat

[Ace Rimmer]

Tools needed
1 good 4 way-Phillips screw driver.
1 coolsat card reader.


How to
1. Unplug the unit from power.
2. Remove 3 screws in the back
3. Remove 2 screws one on each side.
4. Were the card slides into the front there is a pull out tab
on the inside of the unit there is 2 nubs push them very easy
toward the center and push outward. Then remove the plastic tab.
out the front of the unit.
5. Place the card reader inside the unit. On the side of your coolsat
there are 3 nubs and a screw hole. Line the card reader frame up
and put the screw in.
6.Line up the screw hole on the inside of the unit and place the screw in it.
Tighten that screw inside and on the side of the unit
7.Place a small peace or of card board under the main board Or a match book (cspo) and Plug the cord into the slot on the coolsat mother board.
Black wire to the left side.Becarful it’s a tight fit.
(Remove what ever is placed under the main board once the cable has been plugged in)
7. Place the cover back on and put all screws back in.
8.plug it up to power and it’s now ready to have the card