Centauri
03-18-2007, 11:32 AM
JTag instruction for Ariza 700 back to Original FACTORY
**** BEFORE YOU START ****
You might damage your equipment. We will NOT be responsible for any damaged. You have to have at least some understand of what you are about to do. You’ll need a JTag cable to proceed.
Now we can start (I did warn you, did I ?)
Pin layout:
5 X 13 4 3 2 X X X []
X X X X X X X X X X
Make sure to unzip the attachment.
Here is the way I've got it to work :
Run JKey by D2 (part of the attachment)
Select IRD model - FS-5900
Click “Flash Program”
Click “OK” on the next screen
Click “ERASE”
Select “YES (to confirm erase)
* at this stage you might get an error msg. try to Power cycle the IRD (ON/OFF) and than try to ERASE again or you could always use WALL to release
Make sure to let ERASE run for a minimum of 30 sec (or you'll have to redo it)
Click “Program”
Select 700 factory bin - Flash 1(M29W160ET) - Full.bin (part of the attachment)
Let it load
Click OK to disconnect.
Please note:
We've tested this multiple times. We've tested this on Ariza 700. There is a small chance we've missed a step, as it could have been obvious to us.
Please post your reactions, so that I'll be able to refine the steps
**** BEFORE YOU START ****
You might damage your equipment. We will NOT be responsible for any damaged. You have to have at least some understand of what you are about to do. You’ll need a JTag cable to proceed.
Now we can start (I did warn you, did I ?)
Pin layout:
5 X 13 4 3 2 X X X []
X X X X X X X X X X
Make sure to unzip the attachment.
Here is the way I've got it to work :
Run JKey by D2 (part of the attachment)
Select IRD model - FS-5900
Click “Flash Program”
Click “OK” on the next screen
Click “ERASE”
Select “YES (to confirm erase)
* at this stage you might get an error msg. try to Power cycle the IRD (ON/OFF) and than try to ERASE again or you could always use WALL to release
Make sure to let ERASE run for a minimum of 30 sec (or you'll have to redo it)
Click “Program”
Select 700 factory bin - Flash 1(M29W160ET) - Full.bin (part of the attachment)
Let it load
Click OK to disconnect.
Please note:
We've tested this multiple times. We've tested this on Ariza 700. There is a small chance we've missed a step, as it could have been obvious to us.
Please post your reactions, so that I'll be able to refine the steps