JTag instruction for Ariza 750CX back to Original FACTORY

[Centauri]

JTag instruction for Ariza 750CX back to Original FACTORY

I would like to thank Ariza for making the Factory bins available on their site; this made my life easier, thank you.

You should be able to use the same set of instructions:

**** BEFORE YOU START ****

You might damage your equipment. I will NOT be responsible for any damaged. You have to have at least some understand of what you are about to do. You’ll need a JTag cable to proceed.

Now we can start (I did warn you, did I?)

Pin layout:
5 X 13 4 3 2 X X X []
X X X X X X X X X X

Make sure to unzip the attachment.

Here is the way I've got it to work:
Run JKey by D2 (part of the attachment)
Select IRD model - FS-5900
Click “Flash Program”
Click “OK” on the next screen
Click “ERASE”
Select “YES (to confirm erase)

* at this stage you might get an error msg. try to Power cycle the IRD (ON/OFF) and than try to ERASE again or you could always use WALL to release

Make sure to let ERASE run for a minimum of 30 sec (or you'll have to redo it)

Click “Program”
Select 750CX_factory_bin_-_flash_-_full.bin (part of the attachment)
Let it load
Click OK to disconnect.