no lock

[osirus_4]

Every time I try to go into the antenna setting menu I get the message "no lock" and the receiver reboots itself, any ideas? This is just since I tried to flash the factory bin and then bin 1.43 back onto the receiver. Have tried this more than once.

[Web Wizard]

do you have the latest boot file loaded?

[osirus_4]

Yes, I have boot 1.30 loaded. I had to load bin 1.42 in and then I loaded bin 1.43 over it to solve my problem. The problem with that is my original problem from my other post isn't corrected.

[Web Wizard]

ok considering it is a not a file issue only thing thet would cause "nO LOCK" message is either poor dish alignment or your switch settings are wrong in your antenna setup

[Publicraven]

Second that Webbie

[osirus_4]

I don't think that I described the problem very well. The dish alignment is good. What was happening was that when I loaded bin 1.43 the antenna setting menu would not come up at all. Only the "no lock" message that appears in the upper right hand part of the screen appeared, no other graphics or writing at all. The other problem I have noticed is when I plug in my BEV receiver I have a signal in the 90's. With my Pansat I have a signal and quality in the mid 80's to low 90's, but with this NFusion my signal has dropped from low 80's for both signal and quality a couple of weeks ago to 68S 83Q at the present time and no the dish has not moved. Any ideas?

[NOKIA™]

did u factory reset it at any point?

if u didn't ... try it and see if it lets u in