Al Bundy
03-25-2009, 05:32 AM
Using a Motor with your NFusion Nuvenio NV HD
C/P
Using a Motor with your NFusion Nuvenio NV HD
First thing you will need is your latitude & longitude.
Now go into your dish settings & select your sat.
If you are using a diseqc switch go to diseqc 1.0 and set your port for the sat you have highlighted now push your volume up button on your remote till you see USALS and then go down to ok and select it.
Here is where you will need to enter your lat. & long. Go to lat in the list and push ok once you enter your lat depending on where you live you may need to change from east to west, to do this while your on your lat. push ok again and push your chnl up button to toggle between east and west, push ok when you have it to the right one. Now do the same for your long.
now go down to to Go to positionand push ok and your dish should go to the sat you have selected, once your signal & quality come in hit your menu button on your remote and and you will now be back at your initial dish settings menu where you can now do your auto scan.
Once your stb has finished scanning select your next sat and repeat the above steps.
Now if you have no switch just go down to diseqc switch and push your vol. up button till you see USALS then go down to ok and select it. Now start at were you have to enter your lat. & long.
C/P
Using a Motor with your NFusion Nuvenio NV HD
First thing you will need is your latitude & longitude.
Now go into your dish settings & select your sat.
If you are using a diseqc switch go to diseqc 1.0 and set your port for the sat you have highlighted now push your volume up button on your remote till you see USALS and then go down to ok and select it.
Here is where you will need to enter your lat. & long. Go to lat in the list and push ok once you enter your lat depending on where you live you may need to change from east to west, to do this while your on your lat. push ok again and push your chnl up button to toggle between east and west, push ok when you have it to the right one. Now do the same for your long.
now go down to to Go to positionand push ok and your dish should go to the sat you have selected, once your signal & quality come in hit your menu button on your remote and and you will now be back at your initial dish settings menu where you can now do your auto scan.
Once your stb has finished scanning select your next sat and repeat the above steps.
Now if you have no switch just go down to diseqc switch and push your vol. up button till you see USALS then go down to ok and select it. Now start at were you have to enter your lat. & long.