need help with two SV's

[mac94]

:noclue: I just hooked up two 360 elites to same line. One works on all channels, the second only has some working and some "No Signal"
What am I doing wrong? Settings are same for both receivers

[NOKIA™]

post what hardware u have ..dishes/LNB's/switches...

and post ur antenna setup

[mac94]

bell, single LNB nimiq 1,3
both units worked independenly well before I tried to hook up together
Second set has signal on meter

[NOKIA™]

switch location of rcvrs...

to see if u get the same result

if the non working rcvr starts working again ..then it can be a cable/connector issue ... or the port on the LNB is failing...

[smack]

bell, single LNB nimiq 1,3
both units worked independenly well before I tried to hook up together
Second set has signal on meter

Mac,could you explain the "tried to hook up together" part a little more. Post your cabling setup,it may give a better understanding.

[mabs]

same line as in the same cable from the lnb? if so then there lies your problem

[mac94]

I'll get back to you. Had a problem at my job. Broken limbs

[skybliss]

I'll get back to you. Had a problem at my job. Broken limbs

Wow, Mac... Did ya fight with the boss???
Hope ya would be well as before...:eek::box:

[mac94]

My wife is my boss :-) One of my employees had a problem OK now
What I am trying to do is hook up 2 360's one in family room, one in another. If I connect each seperatly to my line in they work. So both work. However when I try to connect the other to the output of no. one I get a good signal but not all channels. IE no 417 Speed. It reads " No Signal" All settings are same on both 360"s some ppv are on others NS >could I have the setting wrong on one of them. This FTA are new to me.

[mac94]

Not sure what you mean. I only have one Lnb on Bev. one line in to house ,do I need two lnb and two lines in for these to work?

[mac94]

Mac,could you explain the "tried to hook up together" part a little more. Post your cabling setup,it may give a better understanding.
I think I'v found something. I ran a seperate line from the extra outlet on my LMB to the second set and all working now
Thanks
Mac94

[mac94]

switch location of rcvrs...

to see if u get the same result

if the non working rcvr starts working again ..then it can be a cable/connector issue ... or the port on the LNB is failing...
Got something working. I ran a seperate line from the second outlet on my LMB to the second set and working now.
Thanks
Mac94

[mabs]

that is what i was trying to say. guess i should have read the title better. yes, you can not loop out to another receiver. just wont work. glad you got your tv though

[skybliss]

Not sure what you mean. I only have one Lnb on Bev. one line in to house ,do I need two lnb and two lines in for these to work?
My friend, i afraid so...sure as clear day. Or ya need a separator to run each one independently...:eek: