caseman
03-22-2008, 10:03 PM
Procedure's for initial IKS set-up via ethernet fo your Neosat PRO, iPro 2000, iPro 2000 Plus Receiver. You should have good sat signal before you begin. The iPro 2000 and iPro 2000 Plus procedure is the same. For PRO ignore the key on the bottom of the adopter. Use embedded key as shown below.
iPRO 2000 Plus Set-Up
Turn on the receiver.
Download software using Rs-232 or Flash memory
follow installation wizard.
scan Channel
connect ethernet
Press F4
input serial number (If you already input from installation wizard, serial key shows and don't need to put again)
press disconnect and connect button
status shows "ligin. ready to channel change"
or "incorrect serial number.
In this case, input serial number correctly and press yellow button in order to save new key.
Watching TV
Pro Set Up
1. Do not power on and connect adapter
2. download software
3. set up installation
4. scan channel
5. turn off the box
6. connect internet to adapter
7. coonect adapter to receiver
8. turn on the adapter and wait until light change to green from red
9. turn on the receiver
10. press F4 button and see the serial key. (Current adapter embedded serial key and not attached serail number on the adapter)
Write down serial number and keep in safe place.
:cool:
iPRO 2000 Plus Set-Up
Turn on the receiver.
Download software using Rs-232 or Flash memory
follow installation wizard.
scan Channel
connect ethernet
Press F4
input serial number (If you already input from installation wizard, serial key shows and don't need to put again)
press disconnect and connect button
status shows "ligin. ready to channel change"
or "incorrect serial number.
In this case, input serial number correctly and press yellow button in order to save new key.
Watching TV
Pro Set Up
1. Do not power on and connect adapter
2. download software
3. set up installation
4. scan channel
5. turn off the box
6. connect internet to adapter
7. coonect adapter to receiver
8. turn on the adapter and wait until light change to green from red
9. turn on the receiver
10. press F4 button and see the serial key. (Current adapter embedded serial key and not attached serail number on the adapter)
Write down serial number and keep in safe place.
:cool: