NETWORK ADAPTER CONNECTION

[Peterbilt]

NETWORK ADAPTER CONNECTION
1. Connect Adapter power cable to power line
2. Wait until adapter light change to green from orange (located on the top of adapter)
3. Connect network cable comes from modem or router to Network adapter
4. Power off NEOSAT Pro receiver
5. Connect Adapter cable to RS‐232 port in the NEOSAT Pro (back side)
Connect provided Adapter power cable
and connect the other side to power line
Adapter Light
Connect Network cable which comes
from Router or modem to here
6. Power on the Neosat Pro receiver
7. Screen will show installation wizard.
8. Follow the step and set up the installation
9. During the installation wizard, if you didn’t scan channels, Press menu/ installation/antenna setup and
scan channels.
10. After scan channel, press F4 button on the remote control
11. Input Serial number which attached backside of adapter.
12. After input serial number, press green button (disconnect) and press red button (connect). It takes 2~3
seconds for processing.
13. Press exit button on the remote control
14. Press F4 button again and you can see the serial number.
15. Ready to use
16. In order to get new file, press F3 button and press red button and check if new file is available.