Problem loading 260puff file

[ceto55]

I think I made a mistake by loading the CS_260T_lzma(PUFF) file. And now my FLU is stuck reading PUFF on the display. It stops on the last F for a few seconds and then starts all over again. I tried to load the first puff file, but to no avail. Is there a way out of this or is my FLU done for? Thank you in advance.

[Rodalice3]

the same thing happened to me,tried to reload file,same thing,so i put in the first time conversion b-75,2500 to 2700 conversion files,,now using the b-75 files,working good here,good luck

[ceto55]

I tried that, too. But when loadind bin, the loader stops when the burn process starts. I'll give it another try.

[Dstealth]

This may help. http://www.dssgeeks.com/forums/convert-cs-260t-t31958/index.html

[ceto55]

Dstealth,
Tried that method this morning, but no better results. When loading, it gets stuck on the burning stage and errors out. Thanks for the effort.

[Dstealth]

--------------------------------------------------------------------------------

This file is to be used Only for the Conversion boxes--works like a jtag(with power obviously) but is NOT a jtag file...if you jtag this file on your box as-is ......I do not know what would happen...but I doubt that it would come ON.

To start OFF

Use UkRoNiC's BOX Updater .420. or BL1.3-1.4 works also....

Using Ukr_-PUFF-ConversionFlashFix.bin (1mb)

Off/On your box...on first light....hit write and be patient.

IF successful write, box should Display 'rolling PUFF'.....

at this point using same loader and same Off/On method...

Load in most recent -PUFF-.bin (448k)

when all done....use channel 8282 and set Default Keys.

Enjoy it

[ceto55]

Can't explain it, but file 261 fixed the issues I was having with my flu. Thanks for all the help. Dstealth, I tried the flashfix file and it didn't work either.