Channel List/EPG/Wireless

[Neno]

Hey guys

So I recently purchased a NFusion Phoenix and set up all my birds: 82, 91, 110, and 119. Upon setting up each bird I did a channel scan, and all the channels came up no problem.

But what I'm wondering is how can I get the names of the channels to show up with a full name, for example Setanta sport is Setna. Other channels also have different names, which make it harder to determine what is what. Would doing a channel scan work better if connected to the internet?

Another problem I have been experiencing is with the EPG, sometimes when I am updating the EPG it will start and stop, and when I go back in then it restarts from the beginning again and it will go to 100 after either waiting 3 min or so. I am unsure if this could be a problem with the wireless set up I have.

In regards to the wireless bridge, I currently only have 2 green lights constantly on both bridges: Link and Link/ACT
I'm unsure if this is set up properly or if I should have 3 green lights instead, as this might be causing a problem with my EPG.

Thanks

[rosadorod]

Originally Posted by Neno

Hey guys

So I recently purchased a NFusion Phoenix and set up all my birds: 82, 91, 110, and 119. Upon setting up each bird I did a channel scan, and all the channels came up no problem.

But what I'm wondering is how can I get the names of the channels to show up with a full name, for example Setanta sport is Setna. Other channels also have different names, which make it harder to determine what is what. Would doing a channel scan work better if connected to the internet?

Another problem I have been experiencing is with the EPG, sometimes when I am updating the EPG it will start and stop, and when I go back in then it restarts from the beginning again and it will go to 100 after either waiting 3 min or so. I am unsure if this could be a problem with the wireless set up I have.

In regards to the wireless bridge, I currently only have 2 green lights constantly on both bridges: Link and Link/ACT
I'm unsure if this is set up properly or if I should have 3 green lights instead, as this might be causing a problem with my EPG.

Thanks

The receiver gets the EPG information from sats,not from internet.If you have encrypted channels open you have no problem with internet.Do a factory default,then a hard reboot,load 150_3 as main,set settings scan again.Then check for the EPG.It's normal if EPG loading stops a few times.If problem persists probably have incorrect switch settings,bad signal or wiring and switch problems.